Characteristics

　　1、Reasonable construction, effectively reducing the floor area.

　　2、Bearings are designed to isolate from water and sand as so to avoid the damage of bearing probably caused by water, sand and impurities.

　　The failure rate can be therefore reduced.

　　3、Optimal design on driving parts facilitates the installation in site

　　4、Special design on guide plates facilitates the excavation and discharging of materials; reasonable screen mesh design combined with optimal

　　design on speed of bucket ensures that the water and impurities in the materials can be discharged maximum.

　　5、Less loss of fine sand and ore powder, the washed sand and fineness module can meet the required standard

　　6、Reasonable design on discharge chute and drainage port facilitates the discharging of materials and water.

　　7、This equipment, excepting the screen mesh, has almost no wear parts needed, its service life is long and no maintenance is required during

　　long running time.

　　8.Big handing capacity, low power consumption, water saving and green environmental protection.

     Working principles:　

　　When the wheel-bucket washing machine operates, its motor, through triangular belt, reducer and gear decelerates and drives the impeller to

　　rotate slowly. The sand which is fed in the washing trough via feeding chute, rolls over driven by impeller and grinds each other in order to

　　remove the impurities covering the surface of the sand, and destruct the vapor- coated sand layer to facilitate the dehydration. At the same time

　　the machine is added with water to form the strong water flow which can take away the impurities and sundries with small gravity to discharge

　　them from overflow port smoothly. The cleaned sand taken away by the impeller is fed into the discharging chute finally as so to accomplish the

　　washing operation.